The common electrical problems are often caused by improper or illegal tapping connection that is sometimes an extension to the current setup or installation. It comes to worst when the installation is not standard and probably you put your place to risk.

Electrical problems in common differ and sometimes it causes by improper usages not only for connection but also for the devices or appliances load that consume electricity. 

Perhaps the common electrical problems and electrical solutions are:

Electrical surges. It sometimes causes due to the low quality of wiring in the house or lighting strikes, improper connection of appliances that fault and power lines damaged.

Replace poor wiring or connection with standards wiring that is recommended by the manufacturer. When electrical surges occur, you must contact your local trusted electrician.

Overloading. As a consumer of electrical or electronic appliances, you must know the scope of usage of your electric supply to avoid overloading. Overloading damage low resistance wire and turn to fire. Be aware when you plan to have extension wire at home, or for better result consult your electrician.

Power sags and dips. It occurs when the power grip is faulty, made of low-quality materials, and electrical appliances that are connected to it.

The junction box that is uncovered. Sometimes junction box leave uncovered that is close in electrical current coincidence.

The switch of light is not working. The bad workmanship is easy to point out. Sometimes the poor quality of products faulty then these must be replaced. Contact reliable electrician.

Flickering light. If you have to experience frayed wiring at home, probably windy outside and the cable move simultaneously, it sometimes put to a higher level of risk and maybe it can start a fire. Call the electrician immediately for fixing.

Less outlets. Today most of the houses install extension cords or outlet. Make sure the wire is resistant to heavy load.

Electric shocks. There is a tendency that the electricity is not properly used then electrical risk occurs particularly in old homes. This issue differs in the circumstances may because of the appliance or the wiring.

No RCCB (Residual Current Circuit Breaker). This is also known as Earth Leakage Circuit Breaker (ELCB). It ensures protection against direct and indirect contact, electric fire, and the short circuit occurs. 

Frequent burning out of light bulbs. When occur you must check if the issue belongs to high wattage, insulation is near to light, the poor wiring on circuit and mains, and more wattage on a dimmer switch.

Over circuited panel. These setups are violating the code. There is a right usage of the panel. You must follow to avoid danger level. To resolve this issue by adding a sub-panel with extra slots or replace the old one. Contact the expert electrician is the best choice to solve the problem.

High electric bill. It often causes, when damaged circuits or wiring, you must reduce electrical usage by unplugging electronic devices when not currently in use. Relying on a cost-effective service provider, and sometimes recognising power surging devices.

Aluminium wiring. The risk is on high danger level as aluminium was used as a cheap substitute for copper in earlier days. There is a tendency the corrosion takes place when aluminium is in contact with copper, and it leads to fires when the connection loosen.

Backstabbed wires. It occurs when loose wires are worst in the case and the thing to do is to switch off the main and contact your experienced electrician.

There is a more problematic issue to talk when it comes to electrical problems and solutions.

Before worst come to worst, if you are planning to install wiring connection for your home or even for commercial building you must seek for professional personnel that is responsible and licensed for doing the job to secure your safeness and avoids any electrical problems.

 For more tips and techniques for electrical services particular in Gold coast, visit chriselec.com.au/blog for common problems and solution. You should be aware of every consequence when an electrical problem issue arises to avoid high risk and for your safety, protect your appliance, high bells and for your home safety.